Advidia "A" Series Manual de usuario descargar pdf (Pagina 69)

Firmware User Manual

Audio

The section Audio is available only for audio-supported models. The user

interface for audio control looks as below:

Parameters

Description

Audio In

The option “Enabled” would activate incoming audio (either line in or built-in

microphone). The option “Disabled” would turn off the incoming audio. In such

case, the video stream is captured without audio.

Audio In

Sensitivity

Choose “High” when the target is farther away from the camera and choose “Low”

when the target is near the camera. Under “High” mode, there may be more audio

noise due to higher level of signal amplification.

Audio Out

Volume

The audio out volume level can be adjusted in the scale of 0-100. It will influence

the volume level of the speakers connected to the camera.

Audio Format

Choose the compression format of audio: PCM, G.711A (A-law) or G.711U (µ-law).

To adjust the volume level of the speakers connected to the PC that runs the Web Configurator in order

to hear the audio from the camera’s microphone or line-in device, go to Live View page and use the

audio controls there:

Audio Muted:

Audio level adjusted to the maximum:

This volume control appears in user interface only when the Audio-in function of the camera has been

“Enabled”.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 111 112

Sin comentarios

Advidia "A" Series Manual de usuario Pagina 69