Advidia "A" Series Manual de usuario descargar pdf (Pagina 41)

Firmware User Manual

IP Settings

The section IP Settings provides the options to define how the camera

would obtain its IP address; and to which DNS server should the camera

connect to, in order to resolve domain names.

Connection Type

The sub-section Connection Type allows defining the method of

obtaining the IP address of the camera. By default, the camera is in Dynamic IP Address mode and

attempts to get the IP address from a DHCP server. If such attempt fails after several seconds (for

example the DHCP server does not exist), the camera will automatically assign itself an IP address, listed

under Static IP Address.

Host Name is used to identify the camera by a DHCP server. In some networks with very strict security

policy, it is required that all the network devices should have their host name, and when the devices

attempt to access the network by requesting an IP address from a DHCP server, the DHCP server would

check if the host name is among the allowed devices. On this page, it is possible to edit the Host Name

and enable or disable the use of host name.

Most installation projects include clear network topology and static IP addresses for each camera. In such

cases, you can change the camera to Static IP Address mode and modify the IP Address, Subnet Mask

and Gateway accordingly.

In some rare cases, the camera may be connected to the control center over Internet. Usually, the most

cost efficient way is to use ADSL connection with PPPoE. To avoid the unexpected changes of IP

addresses by Internet Service Provider upon the restart of the camera, it is recommended to activate a

DDNS service for such scenario, and let the control center connect to the camera by the domain name

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 111 112

Sin comentarios

Advidia "A" Series Manual de usuario Pagina 41