
9
VP-4HCI / HFI:
Figure 2.2 Rear Panel of VP-4
Table 2.2 Rear Panel of VP-4
RS-485 serial interface for connection to pan/tilt unit, speed dome, etc.
Restore the factory default settings by holding the RESET button for 15
seconds after power is turned on.
10M/100Mbps self-adaptive UTP Ethernet interface.
Serial interface for configuration of device’s parameters or used as
transparent channel.
BNC connectors for video input.
BNC connectors for audio input.
3.5mm two-way audio input interface for connection to active pick-up,
microphone, etc.
3.5mm audio output interface for connection to audio output device,
e.g., loudspeaker, etc.
Comentarios a estos manuales